Back to Discussions
34

[Showcase] Controlling a robotic gripper & LCD with OctoBio Kit using Alpha relaxation + jaw EMG

Marco Rossi (Robotics & EMG)Contributor· Posted 11h ago
380 views1 reply

Wanted to share our weekend build using the OctoBio Kit (octobridge.pieeg.com)!

We connected the Octopus 16 over Web Bluetooth and the Elecrow Arduino Starter Kit over Web Serial in a single Chrome tab:

  1. Mode Selection (Alpha Wave 8–13 Hz): Closing your eyes for 3 seconds raises the relax ratio (α / (α + β)) above 0.62, which toggles the servo gripper between Open and Grasp mode on the 16×2 I²C LCD.
  2. Trigger Action (Jaw Clench EMG): A quick jaw clench spikes high-frequency EMG power (> 35 Hz), actuating the servo and lighting the status LEDs!

No firmware flashing was needed after initial setup—everything ran live in Level 4 blocks.

1 Reply

18
youssefCo-Founder & Software Architect
· 11h ago

This is awesome Marco! Combining a slow spectral ratio (α / (α + β)) as a state switch with a fast transient EMG clench as a trigger is one of the most reliable hybrid BCI paradigms. Feel free to publish the DSP side in Signal Pens too!

Your Reply

You'll verify with a quick 6-digit email code when posting.
[Showcase] Controlling a robotic gripper & LCD with OctoBio Kit using Alpha relaxation + jaw EMG — PiEEG Community Discussions